HOW THE HYDRODRILL WORKS:
The Chuck Adaptor is inserted into the chuck of your drill. The Chuck Adaptor, the Shaft and the Male Pipe Fitting are all solidly attached together, and rotate with the drill. The Shaft Bearings allow the Shaft to turn freely. A hose is attached to the Hose Fitting. When the water is turned on and the valve is opened, water runs through the valve and into the Hydrodrill body. The Shaft Seals keep the water from leaking out. There is a hole in the side of the Shaft, and another hole that runs down the length of the Shaft out the end. The water enters the side hole and runs out the end. From there it fills the pipe attached to the Male Pipe Fitting, and from there out through the Hydrodrill Auger.
Cores under sidewalks, driveways, existing landscaping. Eliminates the need for excavation.
Augers range from 1” to 12” Sturdy aluminum housing, welded steel augers, high-strength steel chuck adaptor.
1502 #1 Hydrodrill with 1/2” Chuck, 2” Auger (Shown)
1502 #1 Hydrodrill with 1/2” Chuck, 1” Auger